LEDs have been around since the 1960s and have been used in household appliances since the 1980s, e.g. for volume indication in stereos, switch indicators, etc. In the 1990s, Automotive led work light was gradually used in cars. Generally, if the Automotive led work light is not illuminated, then the bulb has burnt out and needs to be replaced. However, if the bulb is not completely broken, but the brightness is reduced and the light is red and dull, this should not be taken lightly as it could be a precursor to a fault and the reduced lighting capacity is a major safety hazard. There are several reasons for reduced brightness, the most common being dirt on the diffuser glass or reflector of the luminaire, which can simply be removed with a lint or lens paper. This is why it is important to learn how to maintain your Automotive led work light, so do you know how to maintain your Automotive led work light?
Here is the content list:
•Precautions for use
•Avoiding moisture
•Cleaning Automotive led work light
Precautions for use
Do not turn the Automotive led work light on or off too frequently; although the Automotive led work light is about 18 times more resistant to being switched on or off than ordinary fluorescent lamps, this can still affect the life of the electronic components inside the Automotive led work light and therefore the life of the luminaire.
Avoiding moisture
Special attention should be paid to the fact that Automotive led work light should be exposed to humid environments for long periods. A humid environment will affect the electronic components of the LED light drive power supply, electronic components are damp, the life of the lamps shortened. Automotive led work light does not need to be cleaned with water, just wipe with a dry rag with water and try to wipe dry after use on a rainy day, avoid wiping with a wet rag immediately after switching on the light.
Cleaning Automotive led work light
There are several reasons for reduced brightness, the most common being the accumulation of dirt on the diffuser glass or reflector of the Automotive led work light, which can simply be removed with a lint or lens paper. Another reason is that the battery of the Automotive led work light has lost its charging capacity and is running low on power, in which case it will need to be replaced with a new battery. There is also the possibility that the wiring has deteriorated or the wires are too thin, causing an increase in resistance and thus affecting the power supply. This situation not only affects the work of the Automotive led work light, but in severe cases can even lead to a fire caused by the heat of the wiring.
These are the precautions to take when using the Automotive led work light. If you need an Automotive led work light, you can consider our cost-effective products. Guangzhou POPNOW Electronic Technology Co., Ltd. are non-toxic and tasteless, perfect after-sales service, you can have no worries.
